Very low compression

paulmicin · 04-30-2008, 02:19 PM

Finally put it back together. put a new head gasket and water pump just because. but its putting out even more smoke than before. when i got the head back from the machinist it had ridges the whole way across the surface. was it supposed to be like that? also its shooting out smoke from the pcv and theres a lot of pressure in the valve covers.am i going to have to take it apart again and have the head reresurfaced? did i not torque it right, i put it to 75 ft/lbs.
this sucks ass

04-30-2008, 02:19 PM	#16
paulmicin 3" Exhaust Join Date: Oct 2007 Location: Norwalk, Ca Posts: 52	Finally put it back together. put a new head gasket and water pump just because. but its putting out even more smoke than before. when i got the head back from the machinist it had ridges the whole way across the surface. was it supposed to be like that? also its shooting out smoke from the pcv and theres a lot of pressure in the valve covers.am i going to have to take it apart again and have the head reresurfaced? did i not torque it right, i put it to 75 ft/lbs. this sucks ass Last edited by paulmicin; 04-30-2008 at 02:28 PM.