7MGE Engine rebuild

oregonjoe · 09-22-2009, 06:27 PM

Before installing the Intake runner, you will need to route several lines through the runners BEFORE placing the intake on the head. Run the supply and return fuel lines, IAC Hose from the manifold, and water bypass hose through the runner.

Click image for larger version

Name: DriverSideConnectors_IACtoIntake.jpg
Views: 3994
Size: 180.0 KB
ID: 2364

Click image for larger version

Name: DriverSideConnectors_VACBracket_1.jpg
Views: 4321
Size: 200.0 KB
ID: 2365

Click image for larger version

Name: DriverSideConnectors_VACSwitch2.jpg
Views: 3050
Size: 189.0 KB
ID: 2366

The IAC Hose was tricky – it is an L shaped hose that connects to a nipple on the bottom of the Intake Manifold and runs up to the IAC. You can’t see the nipple once the manifold is installed so its much easier to locate and install it first.

09-22-2009, 06:27 PM	#31
oregonjoe 3" Exhaust Join Date: Aug 2009 Location: Southern Oregon Coast Posts: 83	Drivers Side Electrical and Hoses 2 Before installing the Intake runner, you will need to route several lines through the runners BEFORE placing the intake on the head. Run the supply and return fuel lines, IAC Hose from the manifold, and water bypass hose through the runner. The IAC Hose was tricky – it is an L shaped hose that connects to a nipple on the bottom of the Intake Manifold and runs up to the IAC. You can’t see the nipple once the manifold is installed so its much easier to locate and install it first.