How to adjust the clutch

batmmannn · 06-03-2010, 09:50 AM

Stop being a scaredy cat. Jack that sucker up get under it and get Greasy! I have done clutch replacement alone on my back. Was even alone wrestling the trans back in. Of course that was an MK2 so this one is probably a bitch to do. Don't forget to change the main rear seal while you are there. Putting the new plate back in is not too bad with the alignment tool they provide.

Can anyone tell me how bad it is to drop the trans? I know the starter bolts were tough are the rest of the bell housing bolts just as hard or harder to reach?

Just asking cause my clutch engaging seems kind of low to the floor right now.
Thanks, Scott

06-03-2010, 09:50 AM	#8
batmmannn 12psi boost Join Date: May 2010 Location: West Virginia Posts: 320	Clutch Stop being a scaredy cat. Jack that sucker up get under it and get Greasy! I have done clutch replacement alone on my back. Was even alone wrestling the trans back in. Of course that was an MK2 so this one is probably a bitch to do. Don't forget to change the main rear seal while you are there. Putting the new plate back in is not too bad with the alignment tool they provide. Can anyone tell me how bad it is to drop the trans? I know the starter bolts were tough are the rest of the bell housing bolts just as hard or harder to reach? Just asking cause my clutch engaging seems kind of low to the floor right now. Thanks, Scott __________________ 1987 N/A 7MGE Left Hand Drive MK3 Red 5 Speed and Black Auto Supras My Next project is the Batmobile! Last edited by batmmannn; 06-03-2010 at 09:52 AM.