7M GTE ignition timing guide needed...

Bill UK · 12-17-2011, 10:45 AM

Sounds like the gear has been installed 180 degrees out of position on the shaft; the only drawback is when you install the CPS (as you said) you need to turn the gear 180 degrees to compensate. Found this photo below of a CPS when the notches are line-up. Personally I would leave it as it is; it’s only the grove/hole on the gear/shaft that would be wrong for installation.

12-17-2011, 10:45 AM	#19
Bill UK AEM EMS Join Date: Jul 2006 Location: UK Posts: 891	Sounds like the gear has been installed 180 degrees out of position on the shaft; the only drawback is when you install the CPS (as you said) you need to turn the gear 180 degrees to compensate. Found this photo below of a CPS when the notches are line-up. Personally I would leave it as it is; it’s only the grove/hole on the gear/shaft that would be wrong for installation. Last edited by Bill UK; 12-17-2011 at 10:59 AM.