|
|
04-23-2007, 08:53 AM
|
#1 |
|
3" Exhaust
Join Date: Feb 2007
Location: Milwaukee, WI
Posts: 174
 |
Head torque
as a few of you know i just received a new jasper engine about 2 days ago. Most of the engine is done and ready to roll, BUT. Jasper torqed the head to complete factory spec. Meaning 55ftlbs i believe. So how much tighter do you think i can torque this thing? I was thinking 75ftlbs or so. Im buying a new rebuilt 60-1 ct-26 to pair with this new engine. I need the hg to be able to hold a little bit of power
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 7M-GE head torque | zer_gravity | MKIII Supra | 2 | 01-03-2007 11:49 PM |
| Arp Head Stud Torque Settings!?!?!?!?!? | papaleach | MKIII Supra | 2 | 11-22-2006 08:20 PM |
| torque settings for big end shells and cylinder head | johnkarl | MKIII Supra | 4 | 11-03-2006 04:01 PM |
| Head bolt torque | kjhsupra | Non-Generation Specific Questions | 3 | 04-06-2006 09:19 AM |
| Torque Specifications (ARP Head Studs)??? | Dejvid1785 | MKIII Supra | 5 | 03-06-2006 02:59 AM |
Threaded Mode