04-21-2007, 03:07 PM
|
#1 |
|
Stock
Join Date: Dec 2006
Location: Christchurch, NZ
Posts: 4
 |
5M head onto 7M block
I gather this can be done but cant find any info on it, has anyone done it?
|
|
|
|
05-09-2007, 03:49 AM
|
#2 |
|
3" Exhaust
Join Date: May 2005
Location: STL ,MO.
Posts: 206
|
Yes! Yes it can be done... However you will need to find certian parts for it to work..You will basicly have a 6MGE then..You will have to pull the pistons and put in some out of a 5M..Then you will have to have the crank pulley and harmonic balancer off a 6M to make up for the stroke increase.. So long story short just buy a 6M or just upgrade to a 7M altogether..Yes you would have to also swap the harness and ect.on the 7M... The 6M will use the stock external everything from the motor including the ECU and harness only the short block changes..
__________________
83 p-type,5spd,4;10 gears,New 86 cressida 5MGE 195hp,HKS metal head gasket,Cressida injectors,d-port intake runners,No EGR,No cat,Tweaked MAF,Custom cold air intake,Custom rear strut bar,Perfection clutch,Custom 3inch exhaust,4inch bazooka muffler,,Only 2700lbs,, COME AND GET IT!IF YOU DARE!! Please no Honduuuuhhhs!!! http://www.cardomain.com/ride/858848/2 |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 7MGTE block and head | TxSpeedBoy | Import Auto Center | 4 | 07-01-2009 06:33 AM |
| 7mgte head on 7mge block? | RCSG_MK | MKIII Supra | 4 | 01-01-2008 02:01 PM |
| Head and Block Machined?? | 87supraturbo | MKIII Supra | 12 | 02-06-2006 06:51 AM |
| Head Gasket Part II | Bullz_EyE | MKIII Supra | 2 | 01-26-2006 06:30 PM |
| Milling head and/or block | kazam | Non-Generation Specific Questions | 0 | 07-31-2005 11:19 PM |
Linear Mode
