11-14-2007, 04:56 PM | #1 |
Stock
Join Date: Nov 2007
Location: livermore
Posts: 2
|
vibrations under load
i recently bought a 1992 supra turbo when i acelerate the turbo kicks in just fine but at about 4500all the way to red line my engine gives me a vibration and doesnt seem like its pulling any more than it does at 3500 no power loss but no power gain i assume it should continue to increase g forces let me know if you can help
|
11-14-2007, 08:11 PM | #2 |
12psi boost
Join Date: Feb 2007
Location: Waukegan, IL
Posts: 255
|
It may be your center bearing. It is on the drive shaft.
Is your Supra a auto or a 5-speed?
__________________
1987 Toyota Supra Turbo-burgundy exterior w/gray interior+1987 Toyota Supra(N/A) light brown top,dark brown bottom w/light brown interior. |
11-15-2007, 12:06 AM | #3 |
Stock
Join Date: Nov 2007
Location: livermore
Posts: 2
|
i checked the carier bearing and did a full tune up i assume its a sensor of some sort that comes on at that rpm its a manual five speed
|
11-16-2007, 05:21 PM | #4 |
12psi boost
Join Date: Aug 2005
Location: Kuwait
Posts: 292
|
Motor mounts? If you rev it up to that rpm with the hood open you should see the engine jerk up if you have a bad one. That would throw your driveline alignment off quite a bit and could mess up the power.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
stalling under load | marxdenning | Non-Generation Specific Questions | 1 | 01-18-2007 09:51 PM |