Year to Year MGE Swap changes

[Supra2NR]

Originally Posted by Chambers

If you use the oil pump and pan from your old engine it should then fit, before I bought my car, it had a JDM 7M-GE put in it and I can only assume they ran into the same problem, The engine wont matter if its pre/post 89 because a engine is an engine, its the wiring that wont work, I see you know that but it can't hurt in clarification.

From my knowledge and someone correct me if I'm wrong, there was no JDM MKIII Supra that came NA, the NA 7M came from another JDM car, I can't remember witch but if the pan an pump are diffrent then just use your old parts, but I would just spend a little money and get a new oil pump for a 7M-GTE. Hope this helps.

doesnt the post 89 use a diffrent crossmember?
i remember pple saying this cuz they say you can mount a 2jz motor without changing them
they also use diffrent mounts
cuz i had to reuse mine when i did my swap

[Chambers]

Well yea, motor mounts on the frame have to be swapped if the block won't bolt up to the mounts, but I don't think that really applies to the 7M-GE.

[ma70guy]

the jdm 7m comes off a different car cressida you'll have to swap pan off your other engine might as well get a new pump while your at it cause it will be a pain to change it later

[MDellboy420]

honestly u might want to consider a different mechanic..i just recently got a 2JZ for my 90 supra and had a similar problem..my engine came from japan and because all their cars are right hand drive everything on it..including the oil pump and pan..were backwards..if your engine came from a japanese car your prob. gonna have a few other issues swapping it but if you got a good mechanic it should be no problem

[Mr.Bojangles]

Swapping out the pump and pan was all it took. It really has nothing to do with the engine being from Japan, the cross member and pan design are just different between pre 88 and 89 and later. The new engine is in and runs A LOT better than the tired out old engine. Now once the tax refund comes in, she goes to the paint booth and gets a new set of coil overs.
I would be interested in details on your Jz swap because that is where this is all leading up to. I just needed to put in a new 7M to keep me going until I get all the parts together for the Jz swap.