04-07-2008, 12:48 AM
|
#1 |
|
3" Exhaust
Join Date: Mar 2008
Location: WA
Posts: 69
 |
Compression check question...
Hi!
I tried to check the cmpression of my 7M-GE...the gasket on this one is blown and I couldn't warm it up before the testing how the service manual says. So it says 9kg/cm....when I added a bit of oil it was already 12kg/cm The question is HOW BAD IS THIS ENGINE? Do I have to change the rings as well? I appreciate any advice!!! Thank you! |
|
|
|
04-07-2008, 01:17 AM
|
#2 |
|
3" Exhaust
Join Date: Oct 2007
Location: SLO
Posts: 234
|
i dont know the conversion for psi but if you have a blown head gasket you will have low compression. If the compression jumps more than 20PSI i think it is with a wet test you could have a cylinder to ring problem
|
|
|
|
|
04-07-2008, 03:49 AM
|
#3 |
|
3" Exhaust
Join Date: Mar 2008
Location: WA
Posts: 69
|
I measured a good cylinder...
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compression check when cold | gottadiesel | MKIII Supra | 3 | 02-26-2009 07:24 AM |
| compression test question | mastergrader007 | MKIII Supra | 2 | 08-09-2008 12:05 AM |
| Compression Question | Intenseneal | MKIII Supra | 5 | 08-15-2005 10:27 AM |
| compression check | ddmcse | MKIII Supra | 3 | 08-03-2005 11:11 AM |
Linear Mode
