04-16-2008, 02:15 AM
|
#1 |
|
3" Exhaust
Join Date: Jul 2006
Location: Columbus
Posts: 86
 |
Rod bearings went out...
Well I fixed a a BHG after I bought the car. About 2 months later it develops a BAD knock. I am almost sure that a rod bearing went out.
First, I had to drive around 15-20 miles once it developed the knock so could that be enough to screw the crank? Second, is it easier to lift the engine and remove the cross member or to pull the entire motor. Granted I have never pulled and engine before and don't have a lift. Finally, how hard is it to replace the bearings and possibly the crank? Thanks.
__________________
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbo bearings | robwpe | Non-Generation Specific Questions | 2 | 11-19-2007 03:31 PM |
| Front wheel bearings | Al Hanks | MKIII Supra | 1 | 03-10-2007 02:44 AM |
| pistons, rods, bearings | supraman121 | MKIII Supra | 0 | 12-13-2006 02:48 PM |
| Wheel bearings | nickalvrz | Non-Generation Specific Questions | 1 | 08-25-2006 06:52 PM |
| Connecting Rod Bearings? | SupraDave | MKIII Supra | 9 | 08-23-2005 04:22 PM |
Threaded Mode