did you have the rotors turned?

no I did not. I would say that vibration almost doen't exist when I push my brakes...

They get glazed though, always worth it to get them turned or replaced, wouldnt be a bad idea to still do it

OK...it sounds like a bearing but I'm not sure about that.....the car has 112000 miles only...

Did the shims also include spring clips? These clips (2) go into those little holes on top of the pads, look something like wishbones, and work to separate the pad from the rotor when the pressure is off. This also helps eliminate squeaks.

To check the hub bearing, refer to the MK3 TSRM On-Line

OK thanks.....the original spring clips are there so I suppose they are good...