08-12-2008, 10:03 PM
|
#1 |
|
3" Exhaust
Join Date: May 2007
Location: greensboro
Posts: 242
 |
Brake question
I was out today going to put on brake pads. It was really weird, there is a bolt on the bottom but not the top of the caliper? How do you remove the caliper to get the brake pads off? It looks sealed and there is a little rubber piece at the end of the top one. Also how hard is it to replace the lines the one on the driver side front looks like it is cracking?
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prop/Drive Shaft, brake question | spudz29212MKIII | MKIII Supra | 13 | 05-31-2008 07:15 PM |
| anti-lock brake system abs question | linuxgurupodboy | Non-Generation Specific Questions | 0 | 09-30-2007 03:06 AM |
| Maintenance brake and clutch master cylinder fluid | IHateHacks | MKIII Supra | 1 | 04-18-2007 07:15 PM |
| Wilwood MKIII Rear brake kit | ARZ | Arizona Performance | 0 | 03-16-2007 07:46 AM |
| brake question | damdog05 | MKIII Supra | 13 | 07-18-2006 04:01 AM |
Threaded Mode