01-18-2010, 02:26 AM
|
#11 |
|
3" Exhaust
Join Date: Nov 2009
Location: Castro Valley, CA
Posts: 248
 |
not quiting yet....
on the bright side im learning a whole lot about cars..... still dont know much so it turns out one a couple of the grommets on the injectors were leaking. the thing is i cant get the factory ones off. they spin but dont like off. im afraid to put too much pressure and break something else. also theres no crack on the intake runner and the hose nipple looks fine. so im buying another gasket and will try again tomorrow hopefully. and tool to get these grommets off? thanks  
__________________
86 MKIII Supra East Bay, CA 7mge rebuild. http://www.toyota-supra.info/forums/...-tomorrow.html MKIII commercial http://www.youtube.com/watch?v=HY9W3...om=PL&index=27 lightening build http://www.toyota-supra.info/forums/...ing-build.html |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower Ball Joints - Checking here first | Grandavi | MKIII Supra | 3 | 09-20-2008 04:04 AM |
| Picking up my 89 tomorrow | 8uwav6 | Show n Tell | 2 | 03-31-2008 08:08 PM |
| Checking Thermostat | scruffboy | Non-Generation Specific Questions | 6 | 03-09-2006 05:49 PM |
| Supra Noob checking in from Florida | PalmCoastMk3 | Non-Generation Specific Questions | 1 | 12-23-2005 05:08 PM |
| Supra Newb Just checking in | Razor | Non-Generation Specific Questions | 1 | 12-21-2005 04:15 AM |
Threaded Mode