can i re-torque stock head bolts

cre · 12-11-2009, 02:04 AM

I would be flat out amazed if that happened. Worst thing I've ever seen is people stripping the sockets out from not ensuring the driver was in all the way. The stock head bolts are VERY robust.

supraluver4life · 12-11-2009, 02:15 AM

thank you so so much for your help. youve always helped me quite a bit.
and would you mind replying to my thread about removing the fenders front lip and bumper? if you search fender removal it should be right at the top

oh thanks again for all your help

cre · 12-11-2009, 04:27 AM

If I had much to offer on the fender removal I'd gladly offer it up. I'll think it over and post back anything that I can think of which isn't obvious.

Would you mind please posting MKIII specific threads in the MKIII section? Some of the folks there may have worked on the fender more recently than I, for example and they may be more likely to see your post there.
Thanks.

12-11-2009, 02:15 AM	#2
supraluver4life 3" Exhaust Join Date: Nov 2009 Location: Santa Fe, NM Posts: 135	thank you so so much for your help. youve always helped me quite a bit. and would you mind replying to my thread about removing the fenders front lip and bumper? if you search fender removal it should be right at the top oh thanks again for all your help __________________ Cusco front, Tein Rear coilovers Massive DDP, 3'' custom catless exhaust, Tsudo muffler 4.5'' outlet, Apexi cold air intake, Act stage 3 clutch, ct26 turbo (stock)- 10psi +300rwhp "Not driving a car because its too nice, is like not fucking your gf so shes still tight for the next guy"

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
7M-GTE Head torques on stock bolts...	MA70-3.0GT	MKIII Supra	2	11-07-2009 04:58 PM
Arp Head Stud Torque Settings!?!?!?!?!?	papaleach	MKIII Supra	2	11-22-2006 08:20 PM
head gasket bolts	marc	MKIII Supra	6	10-23-2006 07:23 PM
Head bolt torque	kjhsupra	Non-Generation Specific Questions	3	04-06-2006 09:19 AM
Fel-Pro Head Gasket for Stock 1990 Turbo Engine	Benesesso	MKIII Supra	5	03-10-2006 10:52 PM

12-11-2009, 02:04 AM	#1
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	I would be flat out amazed if that happened. Worst thing I've ever seen is people stripping the sockets out from not ensuring the driver was in all the way. The stock head bolts are VERY robust.

12-11-2009, 04:27 AM	#3
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	If I had much to offer on the fender removal I'd gladly offer it up. I'll think it over and post back anything that I can think of which isn't obvious. Would you mind please posting MKIII specific threads in the MKIII section? Some of the folks there may have worked on the fender more recently than I, for example and they may be more likely to see your post there. Thanks.