02-10-2010, 03:20 AM
|
#1 |
|
3" Exhaust
Join Date: May 2008
Location: Sacramento
Posts: 60
 |
MK III turbo clutch setup question.
Hey, just curious because I know I don't keep up with any changes made. But on the turbo supra's, it's a pull type clutch setup, using a release bearing hub and bearing itself with the R154 trans. Is there a way to modify the set up so it uses a push type clutch, like on the w58 trans, so we can delete the release hub? Only reason I ask is I just sheared mine in half in the middle of a race, and I don't like the idea of it happening again. If not, it's no biggy, as i have another one on order, but i'd like to have options in the future. Thanks for the help guys!
__________________
1jz-gte swap (Currently spun #3 rod bearings), Apexi high flow filter, Greddy thrust 3" downpipe, N1 3" catback with cat delete tube, 1 peice driveshaft, Bar and Plate intercooler, and 440 JDM 2jz injectors. Possible 2jz lower block swap in the works if I can't rebuild the 1j. So troublesome. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP PLEASE | Nick0887 | Non-Generation Specific Questions | 4 | 02-28-2009 07:26 AM |
| Dream Offer | Karma_Supra | MKIV Supra | 22 | 10-17-2007 03:04 PM |
| turbo or not ??? That's the question ... | sausa | MKIV Supra | 7 | 03-30-2007 02:22 AM |
| Sequential Turbo Question | suprapoweredsoarer | MKIV Supra | 1 | 06-06-2006 12:13 AM |
| Turbo lag question. | rnoswal | MKIII Supra | 6 | 02-12-2006 05:42 AM |
Threaded Mode