02-12-2010, 04:09 AM
|
#1 |
|
3" Exhaust
Join Date: Nov 2009
Location: Santa Fe, NM
Posts: 135
 |
turbo rebuild, help
so my turbo is blown (makes bad noise, and quite a bit of shaft play) and i was just wondering what was the best rebuild kit for the ct26. any suggestions? i dont really need anything new except for bearings, thrust collar, thrust bearing, thrust spacer, o rings, seal plate, shaft nuts and piston rings (compressor and exhaust side) right?
thank you in advance oh and what are the best types of metals that these parts are made of?
__________________
Cusco front, Tein Rear coilovers Massive DDP, 3'' custom catless exhaust, Tsudo muffler 4.5'' outlet, Apexi cold air intake, Act stage 3 clutch, ct26 turbo (stock)- 10psi +300rwhp "Not driving a car because its too nice, is like not fucking your gf so shes still tight for the next guy" Last edited by supraluver4life; 02-12-2010 at 04:13 AM. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP PLEASE | Nick0887 | Non-Generation Specific Questions | 4 | 02-28-2009 07:26 AM |
| Dream Offer | Karma_Supra | MKIV Supra | 22 | 10-17-2007 03:04 PM |
| Sequential Turbo Question | suprapoweredsoarer | MKIV Supra | 1 | 06-06-2006 12:13 AM |
| Wondering if Turbo needs a rebuild? | Ozark88Turbo | MKIII Supra | 2 | 03-19-2005 07:29 AM |
Threaded Mode