Head gasket replacement

gringoloco87 · 11-24-2010, 08:14 PM

whats the best head gasket out there for 7m i got 87 supra with a 91 jdm 7mge swap old engine was from a junk with unknown miles anyway before replacing engines i did the following

new
water pump
timing belt and tensioner
full gasket kit
hks 1.2 bead hg
thermostat
all the hoses coolant and vacuum
plugs
wires
cap and rotors
arp head studs
you know the basics of buying a used car
any ways 700 miles later she overheated heated and heard a knock i the lower half of the engine so i started to take it apart again took the head off to see the valve to see if i bent one and went to take the hg off and it fell apart in 3 pieces so now im going to do a full rebuild pistons valves bearings and a port and polish the block and head only have about 30k on if that

so basically whats the best head gasket out there need something thats going to take a hell of a beating

thanks guys

next summer 1uz tt build

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Blown Head Gasket?	BillW	MKIII Supra	5	09-17-2010 02:06 AM
Which replacement head gasket is best??	stanley2001	MKIII Supra	2	08-31-2007 01:38 AM
Head Gasket replacement questions.	DavidLeClair584	MKIII Supra	1	06-09-2007 09:17 PM
head gasket replacement	mizuboi	MKIII Supra	2	10-21-2006 05:37 AM
1989 Supra Head Gasket Replacement	rayk5799	Non-Generation Specific Questions	1	08-30-2006 02:37 PM

11-24-2010, 08:14 PM	#6
gringoloco87 Stock Join Date: Nov 2010 Location: new york Posts: 1	whats the best head gasket out there for 7m i got 87 supra with a 91 jdm 7mge swap old engine was from a junk with unknown miles anyway before replacing engines i did the following new water pump timing belt and tensioner full gasket kit hks 1.2 bead hg thermostat all the hoses coolant and vacuum plugs wires cap and rotors arp head studs you know the basics of buying a used car any ways 700 miles later she overheated heated and heard a knock i the lower half of the engine so i started to take it apart again took the head off to see the valve to see if i bent one and went to take the hg off and it fell apart in 3 pieces so now im going to do a full rebuild pistons valves bearings and a port and polish the block and head only have about 30k on if that so basically whats the best head gasket out there need something thats going to take a hell of a beating thanks guys next summer 1uz tt build