04-09-2010, 04:19 AM
|
#5 |
|
3" Exhaust
Join Date: May 2008
Location: Sacramento
Posts: 60
 |
I got my driveshaft from the driveshaftshop. I'm pretty sure if you go to driftmotion or suprastore you can find driveshafts there as well. I got mine for around 320 shipped. But I don't know if you'll find that with the way things are now.
The whole point for me was to both go lighter than the stock 2 peice (by quite a bit), and to eliminate the minor response time lag when you hit the throttle (due to the center support bearing and well, the driveshaft being to seperate peices). Plus I hear that under increased power, the 2 peice doesn't hold up to well.
__________________
1jz-gte swap (Currently spun #3 rod bearings), Apexi high flow filter, Greddy thrust 3" downpipe, N1 3" catback with cat delete tube, 1 peice driveshaft, Bar and Plate intercooler, and 440 JDM 2jz injectors. Possible 2jz lower block swap in the works if I can't rebuild the 1j. So troublesome. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shop in Chicago | tone loc | Shops & Part Reviews | 3 | 08-06-2010 09:45 PM |
| Where do i look for machine shop? | Kevin | MKIII Supra | 1 | 05-15-2009 05:57 AM |
| any sugestion on a shop to buy a jdm 7mgte? | skadaloz | MKIII Supra | 1 | 05-15-2009 05:52 AM |
| Super Duper JDM Shop | HIGH END EAST | Non-Generation Specific Questions | 0 | 10-14-2007 07:48 PM |
| body shop questions | D_Train | MKIII Supra | 5 | 04-11-2007 06:23 PM |
Threaded Mode