05-18-2010, 03:36 PM
|
#6 |
|
Official hall monitor / search nazi - NO SOUP FOR YOU!
Join Date: Oct 2009
Location: Canada, BC
Posts: 837
 |
i just heat wrapped my manifold, and my manifold gasket was barly there...
i would start with where manifold reaches exhaust. also its only like a 1.5$ / foot of the vacuum lines if you think its egr, just buy 10 ft and start 1 vacuum line at a time i replaced every line on mine just because i could for under 30 dollers (it took about 26 feet for my 84 5m-ge) also i have seen these manifolds crack, check for cracks and make sure the heat shield studs are all tight, because they go strait through to the inside of the manifold
__________________
1984 supra - 1uzfe - w58 - 4.10 - 1 piece aluminum shaft. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Antifreeze Leak behind engine on non turbo 87 3.0L supra | eandjautoworks | Non-Generation Specific Questions | 7 | 09-20-2018 06:57 AM |
| Exhaust Cloud when Starting Engine | Jet Krosswind | MKIII Supra | 6 | 09-16-2008 04:54 AM |
| problem seperating engine from manual tranny | Gengus | MKIII Supra | 7 | 01-29-2008 12:10 AM |
| na engine with 3" exhaust? | supraman121 | MKIII Supra | 10 | 01-07-2007 05:00 PM |
Threaded Mode