![]() |
Diagnostic Help
So I need some help! I just bought a MKIII non turbo. Same day I drove home and on the way home the gas would stick at 4000 RPM. So first thing I did was jump on here and look for tips.
First thing I did was run a diagnostic and got the following codes: 24, 32 and 51. I looked them up and first step was to change the air flow sensor. following that I checked and cleaned the ISC. I then reset the ECU and ran the diagnostic again. Now I only get the 51 error. BUT the motor continues to Idl at 3000 RPM. Any one have a tip? Supra AMS |
have you checked the fuses for everything?
just start with the cheapest thing and go up the list from there. http://www.cygnusx1.net/Supra/Librar...aspx?S=FI&P=28 |
Check to see if your TPS is adjusted properly. This only takes a couple of minutes with some basic tools, the steps to do it are here.
|
Help
All right going to check fuses asap.
I noticed just a couple of minutes ago that there is a lot of play in the throttle rod. It moves in a sideways motion of +/- 1cm. Which means that the throttle linkage is not totally sealed. There is a rubber seal that seems to be worn out. Any other tips are much need! Thanks people! Supra AMS |
I had a injector seal go bad one time and it caused a high idle once, spray some brake parts cleaner near the injectors (best stuff to find leaks BTW) and see for idle change, ya never know.
|
All times are GMT. The time now is 03:16 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.