06-17-2010, 03:47 PM
|
#1 |
|
Stock
Join Date: Jun 2010
Location: Amsterdam
Posts: 2
 |
Diagnostic Help
So I need some help! I just bought a MKIII non turbo. Same day I drove home and on the way home the gas would stick at 4000 RPM. So first thing I did was jump on here and look for tips.
First thing I did was run a diagnostic and got the following codes: 24, 32 and 51. I looked them up and first step was to change the air flow sensor. following that I checked and cleaned the ISC. I then reset the ECU and ran the diagnostic again. Now I only get the 51 error. BUT the motor continues to Idl at 3000 RPM. Any one have a tip? Supra AMS |
|
|
|
06-17-2010, 05:11 PM
|
#2 |
|
Official hall monitor / search nazi - NO SOUP FOR YOU!
Join Date: Oct 2009
Location: Canada, BC
Posts: 837
|
have you checked the fuses for everything?
just start with the cheapest thing and go up the list from there. http://www.cygnusx1.net/Supra/Librar...aspx?S=FI&P=28
__________________
1984 supra - 1uzfe - w58 - 4.10 - 1 piece aluminum shaft. |
|
|
|
|
06-17-2010, 05:43 PM
|
#3 |
|
Super Moderator
Join Date: May 2007
Location: Billings, Montana
Posts: 1,034
|
Check to see if your TPS is adjusted properly. This only takes a couple of minutes with some basic tools, the steps to do it are here.
__________________
1989 7MGTE R154 Targa Top White Package w/Blue Interior Driftmotion 57trim CT26, Upgraded Intercooler, 2.25" Hard Pipes, 3" Turbo Back Exhaust with Test Pipe, HKS VPC w/GM 3 bar MAP sensor, APEXi S-AFC, Walbro 255lph fuel pump, ProSport EVO Series Boost / Fuel Pressure / AFR gauges, Lotek a Pillar Gauge Pod, HKS Type 0 Turbo Timer, Eibach Lowering Springs, Tokico Illumina II TEMS struts, custom powder coated Motegi Racing TrakLite wheels |
|
|
|
|
06-17-2010, 05:56 PM
|
#4 |
|
Stock
Join Date: Jun 2010
Location: Amsterdam
Posts: 2
|
Help
All right going to check fuses asap.
I noticed just a couple of minutes ago that there is a lot of play in the throttle rod. It moves in a sideways motion of +/- 1cm. Which means that the throttle linkage is not totally sealed. There is a rubber seal that seems to be worn out. Any other tips are much need! Thanks people! Supra AMS |
|
|
|
|
06-17-2010, 07:34 PM
|
#5 |
|
Intake
Join Date: May 2010
Location: Albuquerque, New Mexico
Posts: 49
|
I had a injector seal go bad one time and it caused a high idle once, spray some brake parts cleaner near the injectors (best stuff to find leaks BTW) and see for idle change, ya never know.
__________________
1991 Toyota Supra 580rwhp617TQ 11.80@117MPH Under Construction 1992 Honda Prelude 400Hp ??TQ 14.0@ 114MPH Time for Update 2007 Cadilliac Escalade daily Knowledge Is Power................... |
|
|
|
 |
| Tags |
| diagnostic |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Just Got A MK3 | Codelicious | MKIII Supra | 20 | 02-12-2010 01:40 AM |
| Did a diagnostic. | redmaro | MKIII Supra | 5 | 02-04-2007 04:43 AM |
| diagnostic scanner | sd88supra | MKIII Supra | 1 | 12-08-2006 03:38 AM |
| so I got a diagnostic... | sd88supra | MKIII Supra | 4 | 04-13-2006 12:39 AM |
| 1995 Supra EGR Diagnostic??? | johnlijo | Non-Generation Specific Questions | 1 | 02-26-2006 10:18 PM |
Linear Mode
