07-17-2010, 09:16 PM
|
#2 |
|
Bone Stock w Upgrades ;-)
Join Date: Apr 2010
Location: Tampa Bay
Posts: 215
 |
Check the CPS side of the harness with an ohm meter. 140 to 180 Ohms with the probe touching the lower right first (G-, or ground), then touch the other probe to the other 3 in turn. should read 140 to 180 Ohms each time. A Supra repair manual is a good invesment. Make sure the engine wiring harness
ground wire bundle is tight. Its located where the EGR VSV valve is mounted low on the intake manifold. I had some strange engine problems one time because the bolt was only hand tight (intermittent ground). Last edited by Bru; 07-18-2010 at 05:10 AM. |
|
|
| Tags |
| 7mgte, code 12, cps, no start, wiring |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuilt hard to crank (high engine resistance); need advice | cbrewster | MKIII Supra | 4 | 09-28-2009 04:52 PM |
| problem seperating engine from manual tranny | Gengus | MKIII Supra | 7 | 01-29-2008 12:10 AM |
| my 1995 supra engine wont fire | gkhawk | Non-Generation Specific Questions | 6 | 08-25-2006 09:58 PM |
| Keeping Engine Cool | mrnickleye | Supra FAQ | 0 | 06-04-2005 10:02 PM |
Threaded Mode