machining mistake - Page 2

Green7mgte · 08-25-2010, 01:16 PM

Quote:

Originally Posted by supraluver4life

so can i just take a belt sander to it?

Quote:

Originally Posted by cre

I'd attack it with a lapping plate with a piece of 320 sandpaper laminated to it and then some diamond lapping compound of decreasing grits to take it down (In fact I've had to do so in the past).

???...........

Bill UK · 08-25-2010, 09:54 PM

A few pics on the subject, not sure if there is a hole at the bottom of the block casting in the first pic, I took this 3 or 4 years ago when I pulled the engine for a bearing repair. Perhaps supraluver4life could confirm.

08-25-2010, 09:54 PM	#12
Bill UK AEM EMS Join Date: Jul 2006 Location: UK Posts: 891	A few pics on the subject, not sure if there is a hole at the bottom of the block casting in the first pic, I took this 3 or 4 years ago when I pulled the engine for a bearing repair. Perhaps supraluver4life could confirm. Last edited by Bill UK; 08-27-2010 at 01:02 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Aluminium piping. Is it a mistake or not?	azerty	MKIII Supra	13	04-30-2008 08:33 PM