10-25-2010, 03:01 AM
|
#1 |
|
Stock
Join Date: Oct 2010
Location: forsyth, il
Posts: 4
 |
do i need to??
Do i need to remove the intake to install the wiring harness when lowering the engine into the engine bay ? I bought a jdm engine and removed the cut off harness from it but i took off the intake to access it easily. So while its hanging on the hoist close to all the way down, is that the way to do it?
thanks dave |
|
|
|
10-25-2010, 05:35 PM
|
#2 |
 Toyota Racing Development Join Date: Apr 2007
Posts: 5,038
 |
Should have left te harness on the engine and disconnected it from The ECU
__________________
If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal.  Tip Jar --->  |
|
|
|
|
10-25-2010, 05:41 PM
|
#3 |
|
Lexus & 550's
Join Date: May 2010
Location: Baltimore
Posts: 526
|
I think it's easier to take just the pipes and not the whole intake to run the wires
|
|
|
|
|
10-26-2010, 03:36 AM
|
#4 |
|
Stock
Join Date: Oct 2010
Location: forsyth, il
Posts: 4
|
Thanks soo much for your response, this will be the first of many questions to come if you guys don't mind..
I will disconnect the ecu as you suggested |
|
|
|
 |
|
|
Linear Mode
