03-25-2011, 02:22 AM
|
#1 |
|
Intake
Join Date: Feb 2011
Location: South of Columbus, Ohio
Posts: 45
 |
how does milling the cylinder head affect the valve timing??
I milled .020" off of my cylinder head, is this going to throw off my valve timing? do i need adjustable cam gears? please advise.
86.5 mk3 7mge non turbo
__________________
86.5 Supra NA: milled head .020, decked block .007, .5mm+ pistons, port & polished intake manifold and cyl head,OBX header, 3-angle, cold air intake, Cometic MLS HG. ALL NATURAL!  CHEVROLET- Cracked Heads, Every Valve Rattles, Oil Leaks Every Time FORD- Flipped Over, Rebuilt Dodge DODGE- Dirty Old Dust Gathering Engine I'd rather drive a Toyota, than push a ford. |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best Cylinder Head Seal | Supra Saiyan | MKIII Supra | 5 | 02-06-2011 01:10 AM |
| torque settings for big end shells and cylinder head | johnkarl | MKIII Supra | 4 | 11-03-2006 04:01 PM |
| Cylinder Head?? | ZauggIt1 | MKIII Supra | 8 | 10-24-2006 01:51 AM |
| Valve Job On Head Now Car Wont Start? | MKIII shujin | MKIII Supra | 4 | 08-07-2006 02:16 AM |
Threaded Mode