02-05-2012, 06:20 PM
|
#3 |
|
3" Exhaust
Join Date: Jun 2011
Location: Wisconsin
Posts: 177
 |
Cause the picker i have is only able to lift half a ton. My resources are limited. i have to extend the arm all the way to get over the engine so thats why taking the trans with ISNT an option. Everything looks disconnected cause its about maybe 1/2 inch to an inch away from the trans. I read two or three forums that say to remove the clutch fork but i dont understand how that would even help. I tried getting the e clip off but its such a pita.
And if your talking about any of the 6 or 8 bolts that actually connect the bell housing tot he engine were easy. the ones behind the head took maybe 5 mines for the both of them
__________________
1988 7M-GTE Manual Turbo, Godspeed IC, Stock HG Torque to 90FP W/ Arp bolts, Silicon water hose kit, silicon vacuum hoses, Godspeed radiator, 2 12" electric fans. Last edited by icey756; 02-05-2012 at 06:24 PM. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP!: 7MGTE engine block info needed | barton | MKIII Supra | 1 | 05-19-2010 05:54 PM |
| HELP!: 7MGTE engine block info needed | barton | MKIII Supra | 6 | 04-14-2010 09:28 PM |
| Well crap! Advice needed with shot engine | finaltable | MKIII Supra | 10 | 03-13-2008 07:35 PM |
| change oil pump without pulling engine | Jjona5 | MKIII Supra | 2 | 02-11-2007 03:29 AM |
| Pulling Engine and trans | adamh88 | MKIII Supra | 3 | 01-15-2007 05:36 PM |
Threaded Mode