7MGE Head Gasket Replacement

69ho · 08-20-2013, 01:03 PM

I am replacing the head gasket on my '89 Supra and noticed on re-assembly that the top surface of the rear timing cover is above the block deck surface from around the middle of the cover over to the left side and at or below the surface going the other way. This engine was rebuilt by the previous owner and it does not appear that the block deck was cut. I would expect to see this across the entire cover if the deck was cut and the cover was not installed and cut as well. I cannot find a good illustration that shows what locates the cover on the block. Maybe a dowel pin is missing? Is this normal? Where should the surface lie; at or below the block deck?

08-20-2013, 01:03 PM	#1
69ho Stock Join Date: Aug 2013 Location: Huntsville, AL Posts: 6	7MGE Head Gasket Replacement I am replacing the head gasket on my '89 Supra and noticed on re-assembly that the top surface of the rear timing cover is above the block deck surface from around the middle of the cover over to the left side and at or below the surface going the other way. This engine was rebuilt by the previous owner and it does not appear that the block deck was cut. I would expect to see this across the entire cover if the deck was cut and the cover was not installed and cut as well. I cannot find a good illustration that shows what locates the cover on the block. Maybe a dowel pin is missing? Is this normal? Where should the surface lie; at or below the block deck?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Blown Head Gasket?	BillW	MKIII Supra	5	09-17-2010 02:06 AM
Head Gasket Replacement	srausaf	MKIII Supra	1	07-23-2007 05:17 PM
Head Gasket replacement questions.	DavidLeClair584	MKIII Supra	1	06-09-2007 09:17 PM
1989 Supra Head Gasket Replacement	rayk5799	Non-Generation Specific Questions	1	08-30-2006 02:37 PM
7MGE - Stuck with changing Head Gasket???	pasupra	MKIII Supra	8	07-31-2006 10:41 AM