Valve Stem Oil Seals

Roger UK · 10-15-2005, 06:26 AM

I had previously seen tips on replacing the Valve Stem Oil Seals without taking the head off . . . but since this site has been re-vamped I have done a search but can't find any . . .

I have a recon engine, but when fitting the new stem seals apparently several of them split . . so they bought 6 more. But one cylinder (No 6) still seems to now have a faulty seal (getting lots of oil sucked into the cylinder on de-celeration, and plug gets REALLY oily)

So as it's just one don't really want to pull the head . . . how difficult is it to do this in situ? I know about putting rope down the plug hole and turning the crank to TDC to stop the valve dropping . . . but how hard is it to get the springs off/on and the stem seals off/on? Any tips from anyone who's actually done this would be very much appreciated!
_________________
1991 3.0i (N/A) Manual, Black Mica. Owned 6 yrs, Mint Bodywork, Daily Driver. Recent Engine Recon (rebored, crank ground, new oil & water pumps etc), New Rad & Catless Exhaust, EGR all removed, Inline PCV Filter (Photos at http://wessexproductions.co.uk/supra )

10-15-2005, 06:26 AM	#1
Roger UK Stock Join Date: Oct 2005 Location: Newcastle, England Posts: 7	Valve Stem Oil Seals I had previously seen tips on replacing the Valve Stem Oil Seals without taking the head off . . . but since this site has been re-vamped I have done a search but can't find any . . . I have a recon engine, but when fitting the new stem seals apparently several of them split . . so they bought 6 more. But one cylinder (No 6) still seems to now have a faulty seal (getting lots of oil sucked into the cylinder on de-celeration, and plug gets REALLY oily) So as it's just one don't really want to pull the head . . . how difficult is it to do this in situ? I know about putting rope down the plug hole and turning the crank to TDC to stop the valve dropping . . . but how hard is it to get the springs off/on and the stem seals off/on? Any tips from anyone who's actually done this would be very much appreciated! _________________ 1991 3.0i (N/A) Manual, Black Mica. Owned 6 yrs, Mint Bodywork, Daily Driver. Recent Engine Recon (rebored, crank ground, new oil & water pumps etc), New Rad & Catless Exhaust, EGR all removed, Inline PCV Filter (Photos at http://wessexproductions.co.uk/supra ) Last edited by Roger UK; 10-15-2005 at 06:37 AM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bad Proportioning Valve?	georides	Non-Generation Specific Questions	5	03-05-2009 03:34 AM
valve cover gasket question?	sevenmgte	MKIII Supra	8	10-01-2008 06:02 AM
egr valve... reusable?	sd88supra	MKIII Supra	3	06-22-2007 06:28 AM
Valve stem seals?	Kuban	MKIII Supra	9	03-27-2007 02:32 AM
Front Main Seals	nickvash0104	MKIII Supra	5	01-08-2006 06:48 AM