HKS VPC wiring diagrams

[cat007]

Hey all,

I have searched the forums and other various places but failed to find anything.

I have recently purchased an HKS VPC.
It has the 1G-GTE chip in it (2Litre JDM motor) but I believe the wiring itself should be the same accross the board.

Coming out of the unit is 3 plugs:

6 pin female - only 5 are accupied (red, black, orange, white, brown) PIC HERE
6 pin male - only 5 are occupied (yellow, green, blue, black, grey(almost looks silver)) PIC HERE
9 pin male - all 9 are occupied (white, yellow, brown, orange, blue, grey(almost looks silver), black, green, red)PIC HERE

The 6 pin male goes to the pressure and intake temp sensor, however on the sensor wiring loom the wire colours are, white, blue, green and yellow.
White and black go to the temp sensor and green blue and yellow to the pressure. The white wire has a bullet connector in the middle - any reason for this? PIC HERE OF BULLET CONNECTOR

The 9 pin male which I can only assume goes to the ecu and engine wiring loom. The wires on this loom are coloured, black, black(red stripe), white, yellow, brown and red. I have no idea what wire goes where.....help!!

The 6 pin female I do now have a loom for aso don't know what this is for


If anyone can let me know what wire should go where etc or post up their manual saying exactly that, would be great!!

Cheers all

Hunt