05-17-2010, 04:09 PM
|
#1 |
|
3" Exhaust
Join Date: Apr 2010
Location: NC
Posts: 136
 |
Sand Suface Rust on block with WD40???
Hey does anyone know if I am allowed to 800grit lightly sand some surface rust of the block?
I am about to put the mhg on and didn't know if that was going to be an issue once the head is torqued down. The motor is on an engine stand and it had been sitting while I was waiting on some parts. I heard I can clean the internals with wd40 and blowing with air. Does that mean I can spray the cylinders and pistons to lube and clean as well, with wd40?? Your help will be greatly appreciated!! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP!: 7MGTE engine block info needed | barton | MKIII Supra | 1 | 05-19-2010 05:54 PM |
| HELP!: 7MGTE engine block info needed | barton | MKIII Supra | 6 | 04-14-2010 09:28 PM |
| decking block, reuse most parts. | jvginpdx | MKIII Supra | 0 | 08-18-2009 07:03 PM |
| prepping block for headgasket question | dannydavi | MKIII Supra | 1 | 12-06-2008 07:44 AM |
Threaded Mode