|
GTE into GE
ok i have a 87 n/a and i would like to put a 87 7mgte with wireing harness and ecu in what problems might i run into like with ignition stuff and otehr wiring. i just want it to go smothly and have a wealth of knowledge before the transformation.
|
Well, aside from looking around the boards for other similar topics, you could also check here: http://4cefed.com/conversion.html
|
wow im confused so you want to make it a turbo to a non turbo ?
|
Quote:
|
yes thank you i want to buy a 7mgte and take out my practically new 7mge then sell both my 7mge's (one with serious rod knock) to buy new parts for my gte
|
i'm not sure about usdm but from what i can tell in jdm (pretty similar i should imagine) you need to just rewire one plug at the fusebox as they use a different type of plug but wire colours are the same
and do the resistor change in the tacho i'm sure someone here has a link to that somewhere :) |
I know about the tacho - thats covered under the conversion notes page i pasted above - but i thought you had to use the whole 7M-GTE loom because it uses a coil pack and different ignition?
|
of course hence you need to change the body harness plug as 7mgte harness don't fit 7mge body harness ;)
|
Damn - now *i'm* confused!! :D
|
wait so what do i need to cahnge on the wiring harness to the body?
|
| All times are GMT. The time now is 08:52 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.