Wiring?????

[ZauggIt1]

Im not trying to start it, i just want to crank it over for a little while to get the oil pump primed. We are going to try and jump the starter to see if it will even crank, i was going to look for some wire schematics to try and figure out those other to wires, but if anyone knows, i would appreciate the help.

[jfunez]

ground a test light and place the tip into the signal wire (small conector) have someone hit the switch and see the test light light up...

• no light....................bad switch or starter relay
• light........................bad connection at the starter or bad starter

if the test light lit..then check for voltage at the positive cable going to the starter.

now the two round connector that u see that apparently u dont know where they go are the knock sensors conectors...see this link...http://www.toyota-supra.info/forums/...ead.php?t=6577

[jfunez]

another important thing is that you should make sure that the block has been properly grounded....

[ZauggIt1]

well i figured out the problem, it was the battery, and cables. those two connectors arent t=for the knock sensors... they are connectors that like need to be bolted to something. i still cant figure it out..

[jfunez]

lol...thats very funny....
next time check the obvious...