04-22-2005, 01:00 PM
|
#1 |
|
Stock
Join Date: Apr 2005
Posts: 26
 |
I have noticed that sometimes putting a JDM Engine into a USDM Chassis can be a problem, I have seen this with honda/acura's mostly. I was wondering if connecting all the wires and all will be a problem when dropping the 7MGTE in this MKIII?
|
|
|
|
04-23-2005, 11:16 AM
|
#2 |
|
7M POWAH! ;)
Join Date: Jun 2004
Location: New Zealand
Posts: 2,312
|
only thing that might be different is it depends on what year engine you get... most plugs are the same but the temp sensor might be different
just with your harness put it on... all should fit.. if it doesn't then swap over the sensors on your engine so your harness fits  but other than that no probs.. if this is just a replacement engine for your existing supra then it's fine 
__________________
Please use the forum to ask your questions as they will get replied to much faster than pming me Pics of my build. "Good girls are just bad girls that don't get caught" Do a diagnostic first! |
|
|
|
|
04-23-2005, 12:27 PM
|
#3 |
|
Stock
Join Date: Apr 2005
Posts: 26
|
Everything fits and is all working fine now. Thanks for your help again.
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| jdm 7mgte cam sensor wiring... | labrat8420 | MKIII Supra | 5 | 09-02-2010 02:32 AM |
Linear Mode
