05-23-2007, 08:12 PM
|
#61 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
 |
ok well the supras back together.. i just have 1 question... on the throttle body...its facing the driver seat and its liek a little thing that connects to a vacuum line im guessing....where does this line come from and go to? cause i see the connector and no vaccum line. its on the back side of the throttle body facing the seat like sticking out of the t.b
__________________
 nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
05-23-2007, 08:15 PM
|
#62 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
and also, i have to put the passenger side timing gear on..how should i go about doing this..ive tried putting the timing belt on it and trying to pull it on but the belt restrics it. ive tried to move the pulley and was succesful but the belt just doesnt want to go on with the gear there
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 02:44 PM
|
#63 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
any1??????
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 07:16 PM
|
#64 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
ok i got the supra running and took it for a spin....but it wont rev past 2.1k rpm..it feels liek fuel cut..i dont know if its cause im out of gas that this is happening...i know of 2 possible things. my tps isnt calibrated, and theres a vaccuum leak on the side of my throttle body that is facing the driver...i see the connector but i dont know where to attach the other end of the hose to.
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 07:44 PM
|
#65 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
ive been searchin thru the tsrm for a vacuum diuagram but i have nothing
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 08:04 PM
|
#66 |
|
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
|
Picture would help a bit. If you have a n/a then there are like three that come off the throttle body two go to this vacuum valve thing and then one goes to the charcole canister via a VSV on the thermostat housing. But as for the turbo I am not sure I usually label everything when I take it off because it helps me locate where it goes back to.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
|
|
|
|
05-24-2007, 10:42 PM
|
#67 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
yea me too..but its a vacuum hose...on a turbo. if you go to ur driver side fender, and look at the right side of the throttle body, facing the driver seat..its the only vacuum line sticking right out of the side.
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 10:43 PM
|
#68 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
and also um the fuel line closest to the driver seat, at the end of the fuel rail has this little cap on the top of it...i took the cap off and the screw thats in the came out ewith it...does that screw have to be screwed in at all?
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 11:09 PM
|
#69 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
k never mid, got the vacuum line problem done..but it still feels like once i hit 2.1k to 2.4k the car just like dies...then falls to about 1.3k and gets power again and dies once it hits 2.1k i cant even get out of 1st
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
|
05-24-2007, 11:23 PM
|
#70 |
|
12psi boost
Join Date: Jun 2006
Location: salem mass
Posts: 329
|
but theres still a vacuum leak sumwhere..i start the car and the idle keeps going up and down it fluxuates about 1k rpm
__________________
nothing but the best -mods- so far K&N intake fipk 3" megan downpipe 3"turbo elbow 4 washers on the wastegate highflow cat short shifter 89+ front bumper, pic soon to come many more upgrades soon |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A/C Problem | schutz86 | MKIII Supra | 9 | 07-20-2008 06:08 PM |
| Second half of the season begins in Aug… | Guest | Off Topic Forum | 2 | 07-19-2005 10:53 AM |
Linear Mode
