03-13-2007, 10:28 PM
|
#1 |
|
3" Exhaust
Join Date: Feb 2007
Location: Milwaukee, WI
Posts: 174
 |
Main pulley removal.
Well im working on doing the front main seal. And i cant seem to get this thing off. The main bolt came off with out problems and then when i put the SST pulley puller on and started to pull of the pulley it got about 1/8th of an inch and it stopped. I figured i was hitting a rust ridge or something of the sort, so i bolted it back to operating position and spray the shit outta it with penitrating oil and tried it again to the same result. I tried just cranking the shit out of it and it actually started to turn the main bolt back in and left a pretty indentation on the bolt.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1980 Supra Crank Pulley (Harmonic Balancer) | steve6163 | Non-Generation Specific Questions | 7 | 06-18-2010 01:47 AM |
| Crank Pulley Removal | go.stfu | MKIII Supra | 4 | 07-12-2007 11:16 PM |
| Front Main Seals | nickvash0104 | MKIII Supra | 5 | 01-08-2006 06:48 AM |
| Measuring Rod, Main bearing sizes | Justin727 | MKIII Supra | 4 | 12-28-2005 01:43 AM |
Threaded Mode