Disabling Electronic Advance. How?
 

I searched the TSRM and my Toyota Hayness manual and did a search on here and cant seem to find how to diable the electronic advance to set iginition timing. How do I diable the electronic advance to set ignition timing?
Is it done by jumping the 2 connector on the diagnostic port?

Anyone????????? please help!!!!!!!!

You jumper the same terminals that you use to check codes, T and E1. Engine must be at full operating temp in order to correctly set base ignition timing.

Page IG-20 in the TSRM.

Page 1-33 in the Haynes manual.

Yeah but in the TSRM it didnt say that using the jumper wire would disable the electronic advance.

I already set ignition timing today. Thanks anyways.