04-03-2007, 09:53 AM
|
#1 |
|
12psi boost
Join Date: Sep 2006
Location: Marysville Washington
Posts: 353
 |
bolt size?
does anyone know the bolt size ill need to get my 7mgte motor onto a engine stand, it mounts to the tranny.
this is what stand i have. engine stand how long do you think they should be? are they fine tread or that other one? and what size is it? thanks alot for your help
__________________
 7MGTE - 500hp  never dyno'dexhaust: 3inch pipes no cat/powerhouse manifold/garret gt47 18psi/HKS SS racing wastegate fidenza cam gears intake: PHR 4inch intake/K&N filter/3 inch intercooler/ pipeFMIC/greddy type R bov/ fuel: 550cc PTE/ walbro 255lp / Aeromotive adj pressure regulator transmission: Fidenza flywheel/ACT extreme kit electronics: map ecu 1 / HKS EVC 9 gauges:boost,EGT,oil temp & pressure/aem AFR |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Little Story about a crank bolt | abhattan | MKIII Supra | 17 | 03-28-2013 01:06 AM |
| stripped rear end bolt | 87 Supra | MKIII Supra | 5 | 10-16-2007 02:40 PM |
| Bolt Snapped - Sealant? | go.stfu | Non-Generation Specific Questions | 3 | 07-25-2007 03:28 PM |
| Broken Bolt | scruffboy | Non-Generation Specific Questions | 6 | 10-31-2006 01:33 PM |
| need info on tranny drain bolt | flight doc89 | MKIII Supra | 2 | 05-11-2006 05:10 PM |
Threaded Mode