05-19-2007, 01:37 AM
|
#9 |
|
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
 |
OK I saw he said auto and I got confused. Then try bleeding the clutch slave cylinder first before taking everything out cause it is easy. Down on the slave cylinder on the tranny there is a little nipple unscrew it a bit and put a catch pan under it and pump the clutch pedal a few times if it spirts a bit when you do so there was air in there. air in the line would cause the clutch to not release all the way.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problems problems problems.... | 86SupraMan | MKIII Supra | 5 | 02-04-2008 04:28 PM |
| Starting problems and accleration problems! | alekjame22 | MKIII Supra | 6 | 03-17-2007 11:19 PM |
| shifting problems | 88_supra | MKIII Supra | 7 | 03-16-2007 10:46 AM |
| problems, problems, and problems | tone loc | MKIII Supra | 6 | 09-06-2006 04:35 AM |
| Question Regarding Shifting Problems | SardonicScotsman | Non-Generation Specific Questions | 2 | 08-09-2005 03:38 PM |
Threaded Mode