water pump and timing belt

[pwpanas]

Originally Posted by wcrispino

Thanks for the response pwanas, just wondering is there a special tool that can be used to get the pulley off. Tried to put a bar to try and crack nut off but is very very tight!!!
Any other advice would be appreciated.
Cheers

If you agree to post back here at every step of the way, I guarantee you we'll get it off.

One step at a time - right now, your problem is that you can't apply enough power to the bolt with the tools you have. The solution to that specific problem is that you simply need more leverage. You need to find/buy/beg/borrow/steal a long, strong pipe that fits the end of your pry bar. Put the pipe on, and push. With a long enough pipe, you could flip your car over, or tear the engine off the motor mounts. However, something else will happen first. For example, your clutch may slip (if you have a 5spd). Post back and tell us what happens next.

[wcrispino]

Hey,
I made a special tool, I got a steel bar and welded the socket to the end of it. I then put a pipe at the end of that as well to get leverage. When we tried to pull on it, it started to bend the steel bar!! I have no idea why its so friggin tight. Is there anything else I can do!!!!?????

[pwpanas]

Originally Posted by wcrispino

Hey,
I made a special tool, I got a steel bar and welded the socket to the end of it. I then put a pipe at the end of that as well to get leverage. When we tried to pull on it, it started to bend the steel bar!! I have no idea why its so friggin tight. Is there anything else I can do!!!!?????

Sound like you need a thicker/stronger, and possibly longer steel bar. Again, step 1 is to get enough power on it. After that depends on exactly what happens *when* (not if) you get it to turn. I guarantee 100% that if you get enough power on it, something will happen.

Hopefully you're using a six-sided impact-grade socket.

You are turning it counterclockwise, right? Sorry...I had to ask.

[wcrispino]

Yeah turning it counter clockwise. Im going to try and get a bigger pipe to put on the socket and hopefully that will do it. Ill keep you updated on what happens.
Thanks

[pwpanas]

Originally Posted by wcrispino

Yeah turning it counter clockwise. Im going to try and get a bigger pipe to put on the socket and hopefully that will do it. Ill keep you updated on what happens.
Thanks

Any news for us? When you get it to turn, it should either make the back wheels turn, make the clutch slip, or engine turn over...or the bolt will break free/loose. Which happened?

Oh, I recall another trick. If you're careful about which way the breaker bar is resting against the ground...very careful...you can use the starter to try to break the crank bolt free. It's kind of risky because if the breaker bar is resting the wrong way, it can do damage including (but not limited to) breaking your a/c lines.