11-22-2008, 12:04 AM
|
#1 |
|
3" Exhaust
Join Date: Nov 2008
Location: California
Posts: 152
 |
Head Gaskets
I'm looking to replace my stock head gasket on my 7MGTE, as far as I know the engine has never been machined, if machining is needed what specs should I have it done to and what thickness and bore should I do for a MHG?!?!?! Also im fairly poor so the most cost effective route would be most appreciated.
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Supra head gaskets? | MA61ME | MKII Supra | 12 | 01-17-2012 01:48 PM |
| Head Gaskets | EthanMKIII | MKIII Supra | 4 | 10-28-2008 12:07 AM |
| Head Gasket Part II | Bullz_EyE | MKIII Supra | 2 | 01-26-2006 06:30 PM |
| head gaskets | cody_18_06 | Non-Generation Specific Questions | 2 | 11-08-2005 02:37 PM |
| Stupid Question about Head Gaskets | scruffboy | Non-Generation Specific Questions | 10 | 11-06-2005 04:23 PM |
Linear Mode
