05-05-2006, 09:32 AM
|
#2 |
|
500whp yet?
Join Date: Jun 2005
Location: CT U.S.A.
Posts: 966
 |
use a breaker bar to loosen the pulley bolt . if you do get it off make sure to to use a torque wrench to put it back on tight. the manual says to torque it down to 196lbs . if it gets loose on you it will damage the inside of the pulley and the crank shaft.
__________________
300+ RW HP Dyno run, jdm,mod turbo,3"exh,electfan,greddyboost Blown HeadGasket info My Supra KiXGaS |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank Shaft Pully Question | kidsusukigsxr | Non-Generation Specific Questions | 1 | 04-15-2011 08:45 PM |
| Crank Pulley Removal | go.stfu | MKIII Supra | 4 | 07-12-2007 11:16 PM |
| question on removing crank shaft | kidsusukigsxr | Non-Generation Specific Questions | 12 | 07-07-2007 03:49 PM |
| Need help with front crank shaft pully bolt | tmetal_blk | Non-Generation Specific Questions | 3 | 06-24-2007 06:24 PM |
| Crank Pully timming | G-string | MKIII Supra | 2 | 05-25-2006 12:11 AM |
Threaded Mode