Forum: Non-Generation Specific Questions
07-07-2008, 10:26 PM
|
|
Replies: 21
Views: 13,271
Kirk
Dude the only reason why you say i dont know what im talking about is because you want people to use your companys product, i have been a mechanic for 10+ years i think i know what i am talking...
|
|
Forum: MKIII Supra
07-05-2008, 07:20 PM
|
|
Replies: 43
Views: 48,877
|
|
Forum: Non-Generation Specific Questions
07-05-2008, 03:43 PM
|
|
Replies: 5
Views: 2,100
Blow off valve location
the blow off valve is usually located on the intake tubing not less than a few inches away from the turbo compressor.
:gotnos:
|
|
Forum: MKIII Supra
07-05-2008, 03:40 PM
|
|
Replies: 43
Views: 48,877
not starting
yes i agree that would work but why just use a temp fix when all you need to do is get a new positive cable that runs from the battery to the starter (selenoid) and then that would take care of the...
|
|
Forum: MKIII Supra
07-05-2008, 01:42 AM
|
|
Replies: 43
Views: 48,877
not startting
Here is what i would suggest, replace the positive cable that goes to the starter, disconnect the negative cable from the body and clean the stud or the firewall where it connects and use a wire...
|
|
Forum: MKII Supra
07-05-2008, 01:36 AM
|
|
Replies: 1
Views: 2,049
no spark
Well i too have an 85 supra.
The one black wire should go to the bottom of the distributor,
I was just out looking at my supra and thats where the one black wire goes on mine, if you need...
|
|
Forum: Non-Generation Specific Questions
07-05-2008, 01:26 AM
|
|
Replies: 21
Views: 13,271
snake oil (head gasket)
Well you think it is going to hold but sorry to say but the stuff you put in will only hold for about a month or so and all that stuff really does is plug the hole and then it will eventually get...
|
|
Forum: MKII Supra
07-04-2008, 10:07 PM
|
|
Replies: 11
Views: 5,128
ok obviousely you dont need advice
well so sorry for trying to help.
I just joined the forum recently and i guess i didnt pay attention to when it was posted, just thaught i would offer some helping advice but ok so sorry to bother...
|
|
Forum: Non-Generation Specific Questions
07-03-2008, 01:53 AM
|
|
Replies: 5
Views: 2,495
boging out supra
to racinrookie88
Well sounds to me like you should take it in put it on a computer to get a code read out and then have a compression test done. Cause if it is the aluminum block when the motor...
|
|
Forum: MKII Supra
07-02-2008, 07:45 PM
|
|
Replies: 11
Views: 5,128
clutch problems
this message is to WBEAMS.
Ok i know this may sound a bit stupid, sometimes when you put a new clutch in a vehicle , when you bolt down the pressure plate before you put the trans back in and it...
|
