Forum: MKIII Supra
05-22-2008, 03:39 AM
|
|
Replies: 2
Views: 2,324
main bearing Q please help
as some of you might know i am rebuilding my 7m gte. I am replacing the main and cap and rod bearings. i went with a standard set of main bearings from napa. when putting the crank back in i...
|
|
Forum: MKIII Supra
03-27-2008, 03:27 PM
|
|
Replies: 4
Views: 2,065
|
|
Forum: MKIII Supra
03-26-2008, 01:30 AM
|
|
Replies: 4
Views: 2,065
shaving the head
The TSRM calls for replacement of head if warped beyond spec and says nothing of replacing it.
i assume it is ok to shave a little off for a blown head gasket since ive read threads on here where a...
|
|
Forum: MKIII Supra
02-21-2008, 11:37 PM
|
|
Replies: 2
Views: 2,884
i already have a tsrm if you read my post. i...
i already have a tsrm if you read my post. i cannot do all of the valve job myself as i do not have the proper equipment, i was reffering more to the valve adjustment. i might not have stated my...
|
|
Forum: MKIII Supra
02-21-2008, 04:56 AM
|
|
Replies: 2
Views: 2,884
variations and questions 7mgte internals
does anyone know if there are any variations for any of the clearances or other specs inside the 7mgte engine over the years. i have a 91 but i am borrowing a toyota manual from a friend for an 88. i...
|
|
Forum: MKIII Supra
01-29-2008, 12:10 AM
|
|
Replies: 7
Views: 4,790
Hey everyone,
ive been through some recent...
Hey everyone,
ive been through some recent family trouble that delayed me in getting it out but its finally out.
I should have listened to everyone on this forum but i like to push my luck.
anyone...
|
|
Forum: MKIII Supra
12-05-2007, 03:23 AM
|
|
Replies: 7
Views: 4,790
thank you oh so much boombastic,
i might have...
thank you oh so much boombastic,
i might have been out there trying to pull them apart for quite a few more hours. i will try again on saterday when i have a full day and a few freinds to help out....
|
|
Forum: MKIII Supra
12-04-2007, 11:01 PM
|
|
Replies: 7
Views: 4,790
i do not beleive the transmission has any...
i do not beleive the transmission has any supports it goes up and down rather freely. we had it supported by a jack. but i guess we just gotta keep everything kinda low, and wiggle and pull till it...
|
|
Forum: MKIII Supra
12-03-2007, 09:42 PM
|
|
Replies: 7
Views: 4,790
problem seperating engine from manual tranny
For anyone that read my other thread i decided to pull the engine. seeing as ive never seen the car run i just couldn't put all that money and work into the head and not know the condition of...
|
|
Forum: MKIII Supra
11-08-2007, 01:27 PM
|
|
Replies: 1
Views: 2,218
New supra owner (not running) here What to do next
I just got a 91 supra turbo with the head already off the block. the previous owner broke his arm right after taking the head off and was forced to sell. the car was supposedly only smoking oil at...
|
|
Forum: MKIII Supra
10-19-2007, 01:07 AM
|
|
Replies: 5
Views: 2,190
|
|
Forum: MKIII Supra
10-16-2007, 09:21 PM
|
|
Replies: 5
Views: 2,190
|
|
Forum: MKIII Supra
10-14-2007, 10:05 PM
|
|
Replies: 280
Views: 63,444
|
|
Forum: MKIII Supra
10-14-2007, 09:27 PM
|
|
Replies: 5
Views: 2,190
|
|
Forum: MKIII Supra
10-14-2007, 02:08 AM
|
|
Replies: 5
Views: 2,190
good deal or not
hi all,
i am considering buying a '91 supra turbo 5 spd. The current owner took the head off because it was burning oil when started up. He broke his arm and has to sell car. The body and paint are...
|
|
Forum: MKIII Supra
04-14-2007, 04:55 PM
|
|
Replies: 1
Views: 2,975
Buying a 87, head gasket questions
Im considering buying a 1987 supra with 50,000 miles. Ive been doing lots of research on the mkiii's and i understand that blown head gaskets are very common. I plan to run severaly tests (analyze...
|
