Forum: MKIII Supra
01-23-2008, 02:27 AM
|
Replies: 0
Views: 3,796
MAF TRANSLATOR & Much More
The Mass Air Flow Translator described here can do a multitude of things. My goal for use is to combine this unit with a high-flowing ROUND GM-MAF. Please see the link listed below to get more info...
|
Forum: MKIII Supra
01-22-2008, 12:58 AM
|
Replies: 3
Views: 2,141
Rod Knock!
yeah, theres no doubt about it, rod knock = rebuild/replacement. were you running petroleum oils?
could have been a bearing in one of many places. at the crank or at the piston. if the oil put in...
|
Forum: Drifting
01-18-2008, 09:12 PM
|
Replies: 8
Views: 4,641
|
Forum: Drifting
01-17-2008, 09:11 PM
|
Replies: 8
Views: 4,641
my 88 na auto (4spd)
i'd like to mention that we just got (in lancaster PA) like 4 inches of snow. Not only can i drift this thing in the dry, but the snow makes drifting STUPID-FUN!!!!
if you put it in first OR...
|
Forum: MKIII Supra
01-17-2008, 04:32 AM
|
Replies: 17
Views: 6,289
I dont have one for the supra, but the talon...
I dont have one for the supra, but the talon build i was involved in used an older model of the MAF trans, (the one that says 'horsepower in a box') and it allowed you to manually tune the car to an...
|
Forum: MKIII Supra
01-16-2008, 10:56 PM
|
Replies: 17
Views: 6,289
did you try using an MAF translator? the MAF...
did you try using an MAF translator? the MAF would more acurately read the incoming air and would even adjust the fuel curve on its own. i would think that if you just slapped a turbo and manifold...
|
Forum: MKIII Supra
01-16-2008, 08:26 PM
|
Replies: 17
Views: 6,289
|
Forum: MKIII Supra
01-15-2008, 08:11 PM
|
Replies: 33
Views: 11,046
|
Forum: MKIII Supra
01-14-2008, 08:32 PM
|
Replies: 33
Views: 11,046
he is right in his diag procedure - spark then...
he is right in his diag procedure - spark then fuel, then compression..... however, most people go haywire checking sensors (me) well before busting out the compression tester... especially on cars...
|
Forum: MKIII Supra
01-14-2008, 08:30 PM
|
Replies: 33
Views: 11,046
|
Forum: MKIII Supra
01-14-2008, 08:15 PM
|
Replies: 33
Views: 11,046
|
Forum: MKIII Supra
01-14-2008, 07:50 PM
|
Replies: 15
Views: 11,345
|
Forum: MKIII Supra
01-14-2008, 07:46 PM
|
Replies: 17
Views: 6,289
YouTube - Colt 4g63T Vs evo8...
YouTube - Colt 4g63T Vs evo8 (http://www.youtube.com/watch?v=3fhua_AU8SI&NR=1)
1991 (for the one we did)Colt Chassis - $400
Wiring Harness For 2.0T - $150
2.0T W/Trans - $900
Intercooler -...
|
Forum: MKIII Supra
01-14-2008, 07:40 PM
|
Replies: 23
Views: 18,610
|
Forum: MKIII Supra
01-14-2008, 07:32 AM
|
Replies: 33
Views: 11,046
timing
you need to have the motor running and at normal operating temperature to properly check timing. just keep that in mind......
pep-boys had a light for 20 bucks, so hopefully you can find one as...
|
Forum: MKIII Supra
01-14-2008, 05:05 AM
|
Replies: 33
Views: 11,046
gotcha. ignition timing is based on factory...
gotcha. ignition timing is based on factory perameters. most cars will read the degrees past TDC the cylinders are, and a certain amount of degrees past that the spark plug will fire. you'd have...
|
Forum: MKIII Supra
01-14-2008, 04:57 AM
|
Replies: 23
Views: 18,610
|
Forum: MKIII Supra
01-14-2008, 04:53 AM
|
Replies: 17
Views: 6,289
|
Forum: MKIII Supra
01-14-2008, 04:40 AM
|
Replies: 15
Views: 11,345
|
Forum: MKIII Supra
01-14-2008, 04:37 AM
|
Replies: 33
Views: 11,046
yes. the crank pulley rotates as fast as the...
yes. the crank pulley rotates as fast as the crank itself. so its gonna be moving pretty quick. the timing light will flash at certain points so that you can see the timing mark 'blink' at you! its...
|
Forum: MKIII Supra
01-14-2008, 03:06 AM
|
Replies: 10
Views: 4,100
Synthetic
I changed the oil in mine when i got it. i got synthetic blend. I wanted the petroleum for the detergent properties, and the synthetic for the superior lubrication properties. after 2 or 3 changes...
|
Forum: MKIII Supra
01-14-2008, 02:45 AM
|
Replies: 17
Views: 6,289
|
Forum: MKIII Supra
01-14-2008, 02:42 AM
|
Replies: 17
Views: 6,289
|
Forum: MKIII Supra
01-14-2008, 02:37 AM
|
Replies: 33
Views: 11,046
the Cam Position Sensor is on the front end of...
the Cam Position Sensor is on the front end of the exhaust camshaft, where on my car (N/A) you would find the distributor (guys lucky enough to have the turbo also get coil packs...). so look at the...
|
Forum: MKIII Supra
01-14-2008, 01:14 AM
|
Replies: 33
Views: 11,046
you've probably already tried this, but if you...
you've probably already tried this, but if you put the pedal down to the floor when cranking..... that would eliminate the vaccuum dependancy for ignition timing while you try to start it.......
...
|