Forum: MKIII Supra
02-05-2009, 02:43 AM
|
Replies: 1
Views: 3,555
|
Forum: MKIII Supra
01-14-2009, 04:34 PM
|
Replies: 4
Views: 3,151
|
Forum: MKIII Supra
01-12-2009, 01:27 PM
|
Replies: 2
Views: 1,971
Check the plug on the ISC, if its loose then it...
Check the plug on the ISC, if its loose then it could cause that, but for reference check page 4 of this page http://www.swaqvalley.com/TSRM/03_EM.pdf, it will direct you to the info for checking for...
|
Forum: MKIII Supra
01-12-2009, 12:35 AM
|
Replies: 13
Views: 7,570
|
Forum: MKIII FAQ
01-12-2009, 12:35 AM
|
Replies: 13
Views: 6,462
|
Forum: MKIII Supra
01-11-2009, 05:02 AM
|
Replies: 13
Views: 7,570
|
Forum: MKIII FAQ
01-11-2009, 05:02 AM
|
Replies: 13
Views: 6,462
|
Forum: MKIII Supra
01-08-2009, 05:04 AM
|
Replies: 5
Views: 2,386
|
Forum: MKIII Supra
01-08-2009, 04:50 AM
|
Replies: 5
Views: 2,386
So the radiator is new as well? If no, then I...
So the radiator is new as well? If no, then I would get a new one, make sure you do not get the one with plastic top and bottom, they tend to explode.
I'm not quite following you about the rad...
|
Forum: MKIII Supra
01-08-2009, 04:23 AM
|
Replies: 5
Views: 2,386
First I have a few questions for you:
Did...
First I have a few questions for you:
Did you replace the radiator or thermostat?
Did you check the water pump or the fan clutch?
If you want to check to see if the cams are in line with...
|
Forum: MKIII Supra
01-07-2009, 09:57 PM
|
Replies: 6
Views: 2,144
|
Forum: MKIII Supra
01-07-2009, 09:51 PM
|
Replies: 2
Views: 2,046
|
Forum: MKIII Supra
12-24-2008, 09:08 PM
|
Replies: 5
Views: 3,478
|
Forum: MKIII Supra
12-18-2008, 04:39 PM
|
Replies: 16
Views: 8,504
Well, there is a lot to do when it comes to...
Well, there is a lot to do when it comes to dropping the cross member, I haven't done it but I have seen a write up on another forum about it. It would be much easer to pull the engine out unless...
|
Forum: MKIII Supra
12-17-2008, 04:33 AM
|
Replies: 5
Views: 4,099
Hi there, welcome. Sounds like you got yourself...
Hi there, welcome. Sounds like you got yourself a very good platform to start from. I would suggest checking out driftmotion.com for a spearco replica intercooler, and intercooler piping kit. Your...
|
Forum: MKIII Supra
12-16-2008, 02:47 AM
|
Replies: 1
Views: 1,984
|
Forum: MKIII Supra
12-15-2008, 05:12 PM
|
Replies: 16
Views: 8,504
Na, what I mean is that it may just be a matter...
Na, what I mean is that it may just be a matter of time before one of our engines finally go, Then we may find out what that knock is by some one taking their engine apart. I have no reason to put...
|
Forum: MKIII Supra
12-14-2008, 11:44 PM
|
Replies: 16
Views: 8,504
|
Forum: MKIII Supra
12-14-2008, 03:15 AM
|
Replies: 2
Views: 2,346
The MAFT Pro, in other words, the top of the...
The MAFT Pro, in other words, the top of the line, hehehe, uses a GM MAP sensor, which will replace your MAF sensor. I believe the lower end MAFT translators do the same but I don't know much about...
|
Forum: MKIII Supra
12-14-2008, 03:02 AM
|
Replies: 2
Views: 2,024
There are cheap kits on ebay, "stainless steel"...
There are cheap kits on ebay, "stainless steel" hehe, the look like Chinese made systems, but the welds look decent, no telling how long it will last though. They are strait pipe, but with the GTE...
|
Forum: MKIII Supra
12-14-2008, 02:56 AM
|
Replies: 16
Views: 8,504
|
Forum: MKIII Supra
12-12-2008, 12:04 AM
|
Replies: 9
Views: 3,473
|
Forum: MKIII Supra
12-12-2008, 12:00 AM
|
Replies: 2
Views: 2,701
|
Forum: MKIII Supra
12-11-2008, 02:27 AM
|
Replies: 9
Views: 3,473
|
Forum: MKIII Supra
12-11-2008, 02:26 AM
|
Replies: 3
Views: 2,364
Get your self a 5/8" 90deg elbow and bypass the...
Get your self a 5/8" 90deg elbow and bypass the heater valve. If it has heat after that then you know the valve is bad. If you still do not have heat then your heater core may be bad, or clogged.
...
|