Toyota Supra Forums! Join the Supra forum!

		Toyota Supra Forums! Join the Supra forum! > Search Forums
Search Results

Page 1 of 3

Showing results 1 to 25 of 67
Search took 0.00 seconds. Search: Posts Made By: Drag0na5h

Forum: MKIII Supra

03-18-2008, 05:37 PM

Replies: 2

Slow Bubbles Into The Resevoir Tank

Views: 3,312

Posted By Drag0na5h

Thanks for the tip. I was wondering what a good...

Thanks for the tip. I was wondering what a good way to test the water pump was so I'll surely do this test today. It's just anytime something doesn't work well on this car I lose confidence in...

Forum: MKIII Supra

03-17-2008, 08:04 PM

Replies: 2

Slow Bubbles Into The Resevoir Tank

Views: 3,312

Posted By Drag0na5h

Slow Bubbles Into The Resevoir Tank

Recently I replaced the heater core vacuum inlet valve unit that opens up to allow hot coolant to flow into the heater core. I believe this was the cause of my consistent coolant loss in the past...

Forum: MKIII Supra

12-20-2007, 07:27 AM

Replies: 5

just got my baby :)

Views: 1,986

Posted By Drag0na5h

I agree, keep it pre 89. Everyone's got the post...

I agree, keep it pre 89. Everyone's got the post 89 look now a days. Keeping the pre 89 front end and swap the post 89 rear end is the most I'd ever do. Nice choice getting an MKIII.

Forum: MKIII Supra

11-11-2007, 07:41 PM

Replies: 5

Megan Racing Compared to ebay strut bar.

Views: 5,711

Posted By Drag0na5h

That Megan strut bar is for the rear, the EBAY...

That Megan strut bar is for the rear, the EBAY ones are for the front. They are raised about 6 inches from the bolting face to make clearance from your engine. Strut bars help complete an upgraded...

Forum: MKIII Supra

09-27-2007, 09:23 PM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

Where was this ground at? On the back of the...

Where was this ground at? On the back of the gauge cluster?

Forum: MKIII Supra

09-27-2007, 08:55 AM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

Yeah when I changed out the old 86.5 column...

Yeah when I changed out the old 86.5 column control switch to a newer 89+ switch I had to modify the contact wires for the cruise control. There was one extra wire on the harness of the new one that...

Forum: MKIII Supra

09-25-2007, 05:47 PM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

Hmmm well they stopped working after you took out...

Hmmm well they stopped working after you took out the gauge cluster right? It's it possible you miss putting in a plug or didn't plug it in all the way?

Forum: MKIII Supra

09-25-2007, 12:41 AM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

In my case I live in a big dismantler city. It's...

In my case I live in a big dismantler city. It's quite easy to find a used Supra and get the gauges out of it. If it's hard to find one I could help you out.

Forum: MKIII Supra

09-24-2007, 09:27 PM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

Yeah looks like the gauge was damaged. As far as...

Yeah looks like the gauge was damaged. As far as your speedometer I checked mine just now and yes it should be at the 0mph mark...but mine is a little bit above 0mph...reading 2mph about. That's...

Forum: MKIII Supra

09-23-2007, 09:12 AM

Replies: 5

Oil pressure guage not working

Views: 3,733

Posted By Drag0na5h

Actually I fixed the old gauge by putting the...

Actually I fixed the old gauge by putting the needle back onto the spring...somehow it flipped off...but since I had a working replacement I figured just use that. I still got the old one as a back...

Forum: MKIII Supra

09-23-2007, 09:06 AM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

I'm sure if you look at the gauge you can figure...

I'm sure if you look at the gauge you can figure out how easily you can put the needle back on the spring so it'll work again. Taking the dash out isn't that hard, just don't rush when doing...

Forum: MKIII Supra

09-22-2007, 08:26 PM

Replies: 7

break lights won't turn off

Views: 3,936

Posted By Drag0na5h

It's possible the little button he's describing...

It's possible the little button he's describing has broken off. I had that problem recently and to fix it I got a plastic press fit rivet to go in the hole to make up for the gap the old button...

Forum: MKIII Supra

09-22-2007, 08:16 PM

Replies: 5

Painting the mouldings.

Views: 2,998

Posted By Drag0na5h

Depending on the condition of your moldings you...

Depending on the condition of your moldings you could take them off and repaint them. All of them have a bolt or screw in them somewhere so don't just try to yank them off. In my case my moldings...

Forum: MKIII Supra

09-22-2007, 08:05 PM

Replies: 20

oil pressure sensor

Views: 6,042

Posted By Drag0na5h

Same thing happened to mine after I replaced my...

Same thing happened to mine after I replaced my engine with a used one from Japan. I noticed right after that my oil pressure reading was completely dead. First I changed out the oil pressure...

Forum: MKIII Supra

09-22-2007, 07:52 PM

Replies: 6

wont go past 3000 rpms

Views: 2,950

Posted By Drag0na5h

When I was readjusting my TPS I did it wrong the...

When I was readjusting my TPS I did it wrong the first time. My RPMs would hit 3000 and drop immediately...after adjusting it properly with the OEM manual it worked normally again. The TPS could be...

Forum: MKIII Supra

09-22-2007, 07:33 PM

Replies: 5

Oil pressure guage not working

Views: 3,733

Posted By Drag0na5h

I'm guessing it's the oil pressure sensor located...

I'm guessing it's the oil pressure sensor located on the engine itself. My gauge before didn't work at all and I thought maybe it was because of that. Changed it out, but I still didn't get any...

Forum: MKIII Supra

09-22-2007, 07:19 PM

Replies: 4

Rear Hatch

Views: 3,152

Posted By Drag0na5h

I replaced my gas struts for my hatch during the...

I replaced my gas struts for my hatch during the summer. Doing so helps to raise the hatch on its own after you lift it up about a foot. And I have a stock wing on my hatch as well. Eventually if...

Forum: MKIII Supra

06-30-2007, 04:23 PM

Replies: 23

Overheating

Views: 6,069

Posted By Drag0na5h

I would drive my car home from work everyday and...

I would drive my car home from work everyday and my overflow would take a massive leak all over the ground as soon as I would turn off my car and get out to see it. Well turns out the problem was my...

Forum: MKIII Supra

06-30-2007, 04:13 PM

Replies: 9

How do i replace these lights?

Views: 3,149

Posted By Drag0na5h

The dome light housing is safe to pop off and on....

The dome light housing is safe to pop off and on. Just grab it with your fingers and squeeze from the front and pull down. It's snap fitted. The lenses in the sun visors maybe be old and could...

Forum: MKIII Supra

06-25-2007, 09:03 AM

Replies: 18

2 new problems....

Views: 4,229

Posted By Drag0na5h

There is a headlight retractor relay in your...

There is a headlight retractor relay in your driverside kick panel. It's a little blue box labeled something like "headlight relay" and in there controls the flipping motion. Maybe it has gone bad...

Forum: MKIII Supra

06-24-2007, 01:27 AM

Replies: 3

passenger window wont open

Views: 3,080

Posted By Drag0na5h

I had the same problem except my passenger window...

I had the same problem except my passenger window wouldn't roll up, but they could roll down. And I could only do so with driver side switch. The passenger side switch didn't do anything. So I...

Forum: MKIII Supra

06-12-2007, 03:10 PM

Replies: 4

Rear brake pads

Views: 3,412

Posted By Drag0na5h

Always put a chock on both sides of one front...

Always put a chock on both sides of one front wheel that is going to stay on the ground when you lift your car up. I'd recommend doing one side at a time since your front wheels don't have any other...

Forum: MKIII Supra

06-11-2007, 05:37 PM

Replies: 16

hmmm well maybe its the tps

Views: 4,191

Posted By Drag0na5h

When I had to adjust my TPS a short while back I...

When I had to adjust my TPS a short while back I found that using a hacksaw blade was a good thickness to put between the throttle and stopper. Then using the Ohm meter setting the TPS to any...

Forum: MKIII Supra

06-11-2007, 05:28 PM

Replies: 4

Rear brake pads

Views: 3,412

Posted By Drag0na5h

Yes that's a very good guide to follow. Just...

Yes that's a very good guide to follow. Just take your time when taking anything off to note what it looks like while it's on so you are confident after the job is finished that it was done right....

Forum: MKIII Supra

04-19-2007, 08:52 AM

Replies: 6

3-Piece Spoiler on my '87 ?

Views: 6,436

Posted By Drag0na5h

You'll want to make sure you seal up the holes...

You'll want to make sure you seal up the holes after you've mounted the wing...dun want you get water damage in your trunk space.

Showing results 1 to 25 of 67

Page 1 of 3

Forum Jump

All times are GMT. The time now is 11:17 PM.